PDA

View Full Version : Printing


JPlute
10-31-2001, 01:54 PM
I have just upgraded from Peachtree Complete for DOS 11 to Classic 12.05. Everything works fine, but I am unhappy with the way some of the reports print. For example the Trial Balance is too far to the left. Other reports stop too high up on the page. I print to a HP Laserjet 8100.

Any suggestions?

Baytek
11-02-2001, 07:56 AM
You can't change the fonts on the reports, but you can adjust the alignment. Under each module's options (except GL), there is a selection for Set Laser Form Alignment. Use this option to move the printed text on the report.

Also, check to be sure the paper type is S for single sheet feed. The default is C for continuous. You can verify the paper type under the Configuration Program (Press F5 from the Company ID screen) in Maintain Printer Setup.

For more information, email support@baytek.com.

JPlute
11-02-2001, 08:51 AM
Thank you. The module that I use the most is General Ledger and that is where my problems are. Let me know if you think of anything else. I do appreciate the response though.